Gemel Txshs User Manual ((install))

For more information on the Gemel Txshs and its features, check out our website or support forum. We're committed to providing you with the best possible experience and look forward to helping you get the most out of your device.

This information is based on user experiences and available technical documentation for Gemel TXSHS devices (FCC ID: F6QTXSHS). Specific alarm behaviors may vary depending on the installation. If you need help, What vehicle (make/model) is this connected to?

: Press Button 2 to confirm full bi-directional communication. 4. Maintenance: Battery Replacement Gemel Txshs User Manual

Ensure the remote is within the motorcycle's reception range. Turn the ignition key to the ON position.

The TXSHS remote typically features two buttons and a status LED: Used to arm the system. Button 2 (Smooth): Used to disarm the system. For more information on the Gemel Txshs and

: Simultaneously press and hold Button 1 and Button 2 on the Gemel remote control.

The Gemel Txshs features an intuitive interface that makes it easy to navigate and access various features. The interface is divided into several sections: Specific alarm behaviors may vary depending on the

Pry open the remote shell casing from the key-ring slot using a small flathead screwdriver and swap out the battery cells.

Keep both buttons pressed until the LED on the remote stops flashing (this usually takes approximately 10 seconds). Release: Release both buttons.

The LED will typically light up once the new battery is seated, signaling it is ready for the resynchronization steps mentioned above. Troubleshooting Common Issues