Satlink Ws-6933 Software Update

You will need to perform a recovery flash. Run the upgrade tool again, select the original factory firmware file, click download, and connect the USB cable while holding down the power button to force the chip into programming mode. Signal Loss After Update

The official upgrade tools are designed exclusively for Windows OS (Windows 7, 10, or 11).

Verify your hardware version before downloading firmware. Satlink has released multiple hardware revisions of the WS-6933 over the years. Flashing firmware meant for a different hardware revision will brick your device. Check the sticker on the back of your device or the "System Information" menu for your specific version. Step-by-Step Guide to Updating Satlink WS-6933 Software satlink ws-6933 software update

Click the , Browse , or File button within the upgrade utility.

Open the upgrade application on your PC. It should detect the device automatically or require you to select the correct COM port. Load File: You will need to perform a recovery flash

A: Because the WS-6933 has multiple hardware variants, try contacting the distributor where you purchased the device. If you're in Europe, reaching out to the listed German support contact may yield the correct file.

Click "Write" to transfer the new TP list to the meter. How to Check Your Current Firmware Version To check if your update was successful: Turn on the WS-6933. Press the MENU button. Navigate to System or Tools > Information . Verify your hardware version before downloading firmware

Fix: Make sure the firmware file is fully unzipped from its .zip or .rar archive before trying to load it into the program. Post-Update Checklist