Bradex Bx60 Battery Charger Manual ^new^ ⏰

The battery is defective and cannot accept a charge. Replace the battery. Safety Precautions

If servicing a maintainable wet-cell battery, remove the cell caps and check the electrolyte levels. Add distilled water if the plates are exposed, but do not overfill.

Unplug the charger before connecting or disconnecting clamps.

Before diving into the manual, let’s confirm you have everything. The standard Bradex BX60 package includes:

Consistently praised as an inexpensive option that "does the job". bradex bx60 battery charger manual

: Never smoke or create sparks near a charging battery.

Turn the charger and allow it to pre-charge the battery for 5 to 10 minutes on the MAX charging setting. This stabilizes the battery chemical composition.

This guide acts as a comprehensive manual for the , covering safety, installation, operation, and troubleshooting to ensure optimal performance and battery life. 1. Safety Precautions: Important Information

The Bradex name is well-recognized in the world of classic battery charging. The company, originally known as Bradville Ltd., was a Yorkshire-based manufacturer that produced some of the most iconic and durable car battery chargers from the 1970s through the 1990s. Enthusiasts often praise these older units for their robust, straightforward design—often a simple "chuck 4 amps at it" approach—in contrast to modern "smart" chargers that may refuse to charge a deeply discharged battery. The battery is defective and cannot accept a charge

Connect a 24-inch (minimum) insulated jumper cable to the Negative (NEG, N, -) battery post.

Understanding the technical limits of your equipment ensures safe operation and prevents damage to your vehicle's electrical systems. 220V–240V AC, 50Hz Output Voltage: 12V / 24V DC (Selectable) Charging Current: 30A (Normal) / 50A (Boost) Maximum Start Current: 200A (Engine Jump-Start Mode) Compatible Battery Types: Lead-Acid, AGM, GEL Battery Capacity Range: 40Ah – 400Ah Protection Rating: IP20 (Indoor use only) Control Panel and Features

: This may indicate a shorted battery or that the clamps are reversed. Unplug immediately. for your Bradex unit?

Plug the charger's mains lead into a wall socket and switch it on. Add distilled water if the plates are exposed,

Remove the clamp first, followed by the RED (Positive/+) clamp. Using the Engine Start (BOOST) Function

Never allow the red (positive) and black (negative) clamps to touch each other while the charger is plugged in.