Echo J7 Cycle Computer Manual Guide

Insert a with the positive (+) side facing up. Replace the cover and twist it firmly back into place. 2. Mount the Bracket

Attach the magnet to a spoke on the front wheel, opposite the sensor.

Before riding, ensure you have all components:

: Current Speed (SPD), Trip Distance (DST), Total Odometer (ODO), Trip Timer (TM), and Maximum Speed (MXS). echo j7 cycle computer manual

Re-enter the setup menu and verify your CC code matches your specific tire size. 4. Display responds very slowly Cause: The operating temperature is too low.

To clear your daily stats (, TM , AVS , and MXS ) before a new ride: Navigate to any screen except the Odometer (ODO). Press and hold the MODE button for 3 to 5 seconds.

The handlebar mount connected via wire to the fork sensor. Insert a with the positive (+) side facing up

button until the display goes blank, then release it to restart the device. Cyclocomputer Echo J7 Manual.epub - Facebook

Check the front wheel. Ensure the magnet passes directly by the sensor arrow. Readjust the gap so it is between 2mm and 5mm. Check the physical wire for signs of tears or pinches. 3. Measurements seem wildly inaccurate Cause: Incorrect wheel circumference code (CC code).

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Mount the Bracket Attach the magnet to a

Before configuration, ensure all hardware components are correctly installed on your bicycle. What is in the Box Echo J7 computer head unit Bracket with handlebar cable and sensor Spoke magnet Rubber shims Cable ties Sensor and Magnet Alignment

: To get accurate speed and distance readings, you must enter your tire's circumference (in mm) into the unit during initial setup. Unit Selection

Typical Features