Once the seat is on, bolt the or stopper onto the back of the rail to prevent the seat from sliding off during use. 3. Attach the Dual-Action Handlebars
Thread it through the pulley attached to the leg developer arm. Terminate the cable at the front low-row link.
If your DP Dual Trac 20 makes a clicking or grinding sound when you use it, the cause is often a slightly loose pulley or a cable that is misaligned. Go back and check that all pulley bolts are tightened evenly and that the cable is seated correctly in every pulley groove. Assembly Instructions Dp Dual Trac 20 Manual Pdf
: Lat bar, rowing/curl bar, ankle strap, and an extension cable. Are you missing a specific part
Wipe down the vinyl pads with a damp cloth and mild soap to remove sweat oils. After Every Use Once the seat is on, bolt the or
: Thread the cables through the pulley wheels. The Dual Trac 20 is designed for over 40 exercises without changing cables, so ensure the rowing/curl and lat bars are correctly hooked into their spring-loaded clips. Attachments
Approximately 69" x 96" x 38" when fully extended. Terminate the cable at the front low-row link
Connect the base of each to the main frame using the provided pins or bolts.
: Once all components are aligned, go back and fully tighten all carriage bolts and lock nuts to ensure a structurally sound, freestanding unit. Sears PartsDirect
: Place the small top plate over the stack to secure the T-bars and prevent the weight post from being removed during use. Secure the Pin