Sinotimer Mc101 Manual | Patched
Navigating the interface requires understanding the function of the four primary buttons:
OUT1 / OUT2 : Glows when primary or secondary control outputs are powered on.
Connect the resistor element between Terminals 8 and 9 , with the third "extra" wire going to Terminal 10 . Control Output: sinotimer mc101 manual
This comprehensive guide serves as the ultimate , walking you through the specifications, wiring diagrams, parameter settings, and troubleshooting techniques. 1. Sinotimer MC101 Overview and Specifications
Use to select your sensor code (e.g., K for K-type, Pt for PT100). Press SET to confirm. 3. Changing Temperature Units ( C-F ) In the main menu, locate the C-F parameter. Press SET to modify. Select C for Celsius or F for Fahrenheit. Press SET to save. Tuning and Operation Running the Auto-Tune Feature Set to 2 for SSR
This indicates an input error. Check that your thermocouple is connected correctly and securely to terminals 9 and 10. If using a Pt100, ensure all three wires are connected correctly. How do I switch from Celsius to Fahrenheit? Enter the Parameter Menu, find the setting for or unit selection, and switch it from Why is my temperature exceeding the set point (overshoot)?
The most common daily operation is setting the desired temperature. Enter the Parameter Menu
: Connect the positive wire to Terminal 10. Connect the negative wire to Terminal 9.
To access the deep programming menu, press and hold the button for roughly 3 to 5 seconds. Use the SET button to scroll through parameters, and use the arrow keys to modify values. Parameter Code Description Default / Common Settings Input (Sn) Selects your input sensor type. 0 for K-Type; 21 for Pt100 Unit (C-F) Changes temperature unit between Celsius and Fahrenheit. C or F Proportional (P) Proportional band setting. Set to 0 for ON/OFF control. System Dependent (Default ~20) Integral (I) Integral time constant. Eliminates offset error. System Dependent (Default ~240) Derivative (D) Derivative time constant. Prevents overshoot. System Dependent (Default ~60) Cycle Period (T) Control cycle period. Set to 2 for SSR; 20 for mechanical relays Alarm 1 (AL1) Sets the trigger temperature value for Alarm 1 output. User Preference Hysteresis (Hy) Dead-band range when using ON/OFF control. Default 2.0 Sensor Bias (Pb) Calibrates the sensor if it displays an offset error. 0.0