Xycd60: Manual

is and does not change voltage or limit current. It is a simple voltage controller that uses an onboard high-capacity relay to mechanically turn an external charger or load circuit on and off. Technical Specifications

The module features two core programmatic profiles. Selecting the right profile dictates how the physical relay responds to voltage changes. 1. Charging Control Mode ( IN )

The XY‑CD60L is a slightly enhanced version that often includes additional timer functions, the same 6–60 V operating range, a similar LCD interface, and is frequently used in solar charge controller applications.

For the most detailed, up‑to‑date information, refer to the manufacturer’s documentation. xycd60 manual

Please note: The XYCD-60 is a widely manufactured generic temperature controller. While this guide covers the standard hardware and functionality, specific wire color codes or port layouts may vary slightly between production batches. Always verify the markings on your specific device's terminal blocks before final wiring.

If you are looking for specific wiring diagrams for your battery type, tell me:

The controller typically features a four-button interface: is and does not change voltage or limit current

When the battery voltage rises to or exceeds the configured Upper Limit Voltage ( UP ), the relay turns OFF (opens the circuit) to halt charging and prevent over-voltage damage. 2. Discharging Mode (OUT) Designed to protect batteries from deep depletion by loads.

The XY-CD60 functions as a voltage-controlled switch that can operate in either charging or discharging mode to protect your battery bank. XY-CD60

The mystery of the "xycd60 manual" remains unsolved, but this report provides a foundation for further investigation and exploration. Selecting the right profile dictates how the physical

The relay turns on when the voltage is below the lower limit (dn) and turns off when the voltage reaches the upper limit (UP).

for about 3 seconds to enter the parameter setting interface. Short press SET to cycle through the parameters: UP : Upper limit voltage. dn : Lower limit voltage. OP : Conduction time (00:00 to 99:59, or "----" to disable). dOP : Delayed conduction time (0–999 seconds). FOP : Forced start time (0–10 seconds) in discharge mode. Use UP/DOWN buttons to adjust the values. Press and hold SET again to save and exit. Voltage Percentage Calculation

Max 10A (though 8A is recommended for long-term stability).

For those looking to integrate this into a DIY solar project, you can find the module on sites like AliExpress