: Slide the bottom panel in from the front and secure it. The rear panel requires significant fastening, typically using nine screws total.
A key, often highlighted step is installing the hinge kits, which allow the side panels to swing open easily rather than just sliding off. Removable Motherboard Tray:
The SMA8 is designed to support the heaviest water-cooling setups and high-end hardware. Below are the key specifications typically found in the manual: Super Tower / Modular Motherboard Support: HPTX, E-ATX, ATX, Micro-ATX, SSI-EEB Radiator Support: Top: Up to 480mm (or 4 × 120mm) Bottom: Up to 560mm (or 4 × 140mm) Front: Up to 480mm (or 4 × 120mm) Drive Bays: Extensive 5.25" and 3.5"/2.5" modular bays.
Place the top frame panel across the four upright corners of the chassis structure. Insert and loosely tighten all top frame screws. caselabs sma8 manual
To clean panel surfaces post-assembly. Workspace Setup
Align the lift-off hinges on the doors with the hinge pins on the chassis frame. Lower the doors into place. The SMA8 features magnetic or latching doors depending on your specific version modification.
Align the vertically with the back edge of the bottom panel. Secure it using four frame screws from the underside and inside corners. : Slide the bottom panel in from the front and secure it
For those looking to restore or modify an existing SMA8, third-party accessories like distribution plates from Singularity Computers are still popular for enhancing the case's water-cooling capabilities.
To install an accessory, simply remove the blank covers and screw the accessory into the vertical rails. 7. Cable Management & Finishing Cable Pass-throughs
Install your Power Supply Unit (PSU) in the lower basement compartment. The SMA8 features adjustable PSU mounts, allowing you to accommodate massive, high-wattage power supplies or even dual-PSU setups. Mastering SMA8 Water-Cooling & Radiator Configurations Removable Motherboard Tray: The SMA8 is designed to
The manual typically details the assembly of the "gunmetal gray" or "black" aluminum panels and highlights the case's vast modularity:
If you are using the manual to check compatibility, here are the core SMA8 stats: SSI-EEB, XL-ATX, E-ATX, ATX. Radiator Support: Bottom: Up to 480mm or 560mm (depending on the mount). Top: Up to 480mm or 560mm. Front: Up to 360mm. Expansion Slots: 8 slots. 4. Visual Resources
Lay the case flat on a stable surface (such as a large table with a non-marring mat).
The SMA8 manual outlines a specific, modular assembly process. It is highly recommended to follow these steps sequentially to avoid damaging the aluminum panels. Phase 1: The Foundation and Bottom Assembly